$3 Garage Sale Table Frame Turned Bench

$3 Garage Sale Table Frame Turned Bench

Happy Sunday everyone!  Today, we are going to share how our $3 garage sale table frame turned bench.  As you all know, our daughter is getting ready for her own place, and we are starting to put the pieces together for the big move in.  At a garage sale, we found a $3 table frame treasure!  The old metal table frame that was silver and gold, was turned to bright and beautiful!

Needs List:

-Old table frame (We found ours at a garage sale)

-Steel Wool

-Paint with Primer (any color you like)

-Clear spray sealer

-Gray Spray Paint (you can use any color you like)

-¾” Plywood 2 ft x 4 ft long (hardware store or scraps from the garage)

-Mod Podge Glue (or your favorite adhesive glue)

– 2 ft x 4 ft piece of 5 inch high density foam

-Batting

– 4 sheet metal screws

-2 yards of fabric (your choice – when you go shopping don’t forget your coupon to have an even bigger savings!)

What we did:

1.   First, scratch the metal garage sale table frame with steel wool so the paint will adhere better to the slick surface. We also had plastic circles we had to pop out of our table that we also rubbed with steel wool.  We then spray painted the circles with RustoleumⓇ Paint and Primer in One in a Metallic Nickel color.

006

2.   After scratching up the surface we hand-painted the frame using BehrⓇ Paint and Primer in One,  in the color Hazelnut Cream (the same color we used in the ottoman project) because Crysta decided she wanted paint strokes in the piece giving that wood look.

048

3.   When the paint is dry, we sprayed the piece with a clear sealer so paint has a protective layer.  Then we hammered the plastic circles back into place.

049

4.   To create the bench top for our garage sale table frame we then cut a 2’x4’x3/4″ piece of plywood.  We had to trim about two and a half inches off so our foam and plywood matched the same dimensions.  This also gave us about a one inch overhang on each side so we could easily attach our fabric which you will see in later steps.

052

5.   After the wood and the foam were cut the same length, we secured the plywood bench top to the metal garage sale table frame by drilling holes in both the plywood bench top and the metal frame and attached using sheet metal screws.  With a metal frame this is important so the two pieces (the wood and the metal) have a better bond.

060

6.   After the plywood bench top is secured to the table frame we then glued 5 inch high density foam we purchased from Joann’s Fabric that was ½ price (we love a sale!). We used this foam to top the plywood seat, and covered that with white batting so the green foam color would not show though the fabric.

063

065 068

7.   Last, we added our fabulous fabric of chevron print that is grey and cream.  We purchased the fabric from one of our favorite craft stores, Hobby Lobby for $8.98 a yard (we had a whopping 40% off coupon lowering that fabric down to our price range), using 2 yards, we covered the foam and stapled under the 1” over hang.

074 077 083

With all materials the total cost of this piece was under $40! To think it all started with a $3 garage sale find.  Thanks for stopping by!

-LC

Leave a Reply

Your email address will not be published. Required fields are marked *

Comment *